Skip to main content

Typical Install Diagram (Omni & Litebeam)

The purpose of this diagram is to give a technical overview of the typical LiteBeam + Omnitik5ac install described in the Typical Installations page - scenario 2


  • The last two octets of the 10.68.x.x/16 and 10.69.x.x/16 (mesh backbone) addresses are determined by node number

  • The last three octets of the 10.x.x.x/26 (member side of the OmniTik) network are also determined by node number and are calculated by the OmniTik5ac config on line 5. Each NYC Mesh LiteBeam/OmniTik installation has one of these unique /26 networks on the member side of its OmniTik. The OmniTik provides DHCP to this network, with the bottom and top 5 usable addresses being left out of the scope (for static assignment to home-routers, LiteBeam management etc). DNS is provided by This 10.x.x.x/26 network is redistributed to the mesh backbone via OSPF.

  • LiteBeam5AC config here

  • This diagram was created on (formerly The diagram source is attached to this page.